Internal Reference:
268422
Barcode:
1872025007123
The unit is equipped with a high-efficiency 16W germicidal UV lamp rated for an operational lifespan of up to 9,000 hours, ensuring year-round biological protection. Powered via an electronic ballast connected to standard 220–240 V / 50 Hz mains, it consumes only 16 W of power. For enhanced electrical safety in domestic and utility plumbing setups, the stainless steel reactor body includes an integrated protective grounding bolt. Its compact inline geometry allows straightforward installation beneath kitchen counters, alongside water coolers, or as an advanced disinfection stage in reverse osmosis and sediment filtration lines.
Functional Features:
253.7 nm Germicidal Disinfection: Neutralizes pathogenic microorganisms and spores at the cellular level without chemicals or secondary by-products.
High-Flow Capacity (0.48 m³/h): Provides continuous on-demand water purification at rates up to 480 liters per hour.
Heavy-Duty 304SS Housing: Fabricated from corrosion-resistant 1.2 mm thick AISI-304 stainless steel tested for operating pressures up to 145 psi.
Extended 9,000-Hour Lamp Life: Offers up to a full year of continuous, 24/7 water disinfection before scheduled replacement.
Standard 1/2" Male Ports: Enables direct integration with standard domestic plumbing, pre-filtration manifolds, and water treatment setups.
Technical Characteristics:
Product Type: Ultraviolet Water Sterilization System
Brand / Series: Luxe Style
Lamp Wattage: 16 W
Maximum Flow Rate: 0.48 m³/h (480 L/h)
Lamp Base / Holder: 4 Pins Single Ended
UV Wavelength: 253.7 nm
UV Intensity (distance = 1 m): 36 µW/cm²
Lamp Lifespan: Up to 9,000 hours
Housing Material: AISI-304 Stainless Steel (1.2 mm wall thickness)
Maximum Working Pressure: 145 psi (9.9 bar)
Inlet / Outlet Connection: 1/2" M
Operating Voltage / Frequency: 220–240 V / 50 Hz
Working Water Temperature: +10 to +60 °C
Turbidity Requirement: < 0.1 NTU
Maximum Total Dissolved Solids (TDS): Up to 2000 ppm
Please note: UV disinfection requires optical water clarity to remain fully effective. Feed water turbidity must be kept below 0.1 NTU; installing a 1-micron polypropylene sediment pre-filter upstream of the unit is strongly recommended. The stainless steel housing must be connected to an electrical safety ground via the dedicated ground terminal. Replace the UV lamp annually (approximately every 8,000–9,000 operating hours), and periodically inspect and clean the inner quartz sleeve to prevent mineral scaling.
More Products
These other products might interest you

